TM 10-6640-238-13
4-128
INSTALL
Install JFTOT. See Figure 4-48.
WARNING
Two people are required to install JFTOT tester because of its weight. Failure to
comply with this warning could result in serious injury to personnel or damage to
equipment.
a.
Install JFTOT (2) into mounting frame (3).
b.
Place JFTOT (2) with foundation in position on countertop (7).
c.
Install 12 washers (6), nuts (5), and cap nuts (4) that secure JFTOT foundation to countertop (7).
d.
Slide JFTOT (2) unit into its retracted position.
e.
Latch three retaining latches (1) on both sides of JFTOT to mounting frame (3).
f.
Plug JFTOT power cord into wall receptacle.
g.
Verify proper operation.
NOTE
For component replacement refer to commercial manual.
CALIBRATE
Refer to vendor manual for JFTOT calibration procedures.
|
|
