|
|
|
|
|
TM 10-6640-238-13
3-15
INSTALL
1.
Install Fluorescent Lamp. See Figure 3-1.
NOTE
If center (blackout) lamp (5) is being replaced perform steps a through d. If replacing
white lights, proceed to step e.
a.
Insert lamp (5) into blue filter tube (8).
b.
Wrap one layer of 3/4 inch tape on both ends of lamp (5) to extend onto blue filter tube (8) 3/8 inch.
c.
Insert lamp (5) with blue filter tube (8) into slots and rotate 90 degrees. Reposition lamp retaining clips (3).
d.
Rotate two standoff brackets (7) 180 degrees and tighten four screws (6).
e.
Position lamp retaining clips (3) and align lamp (4) prongs with slots in light assembly.
f.
Insert lamp (4) into slots and rotate 90 degrees. Reposition lamp retaining clips (3).
g
Install lamp diffuser (2) and secure by tightening four captive screws (1).
h.
Place appropriate circuit breaker in the ON position. (See Table 2-2 or 2-3).
2. Install Fluorescent Lamp Starter.
NOTE
It may be necessary to remove adjacent lamp prior to installing starter.
a.
Align starter (9) prongs with starter slots in light fixture.
b.
Insert starter (9) into slots and rotate 90 degrees.
c.
Install lamp diffuser (2) and secure by tightening four captive screws (1).
d.
Place appropriate circuit breaker in the ON position. (See Table 2-2 or 2-3).
|
|
|
|
|
Privacy Statement -
Copyright Information. -
Contact Us
