TM 10-6640-238-13
3-1
CHAPTER 3
OPERATOR MAINTENANCE INSTRUCTIONS
Section I. LUBRICATION INSTRUCTIONS
Lubrication instructions for the mobile semitrailer-mounted petroleum laboratory, doors, leveling jacks, landing gear, may be
found in TM 9-2330-362-14&P. For lubrication instructions concerning the environmental control units (ECU), refer to
TM 9-4120-371-14. Lubrication requirements for other equipment used in Mod Lab A are contained in their respective
Technical Manual (TM) or commercial manual.
Section II. TROUBLESHOOTING PROCEDURES
Alphabetical Index
Paragraph Title
Paragraph
Introduction....................................................................................................................................................... 3-1
Troubleshooting................................................................................................................................................ 3-2
3-1.
INTRODUCTION.
This section contains operator troubleshooting information and procedures for locating and correcting common malfunctions
which may develop in Mod Lab A.
Table 3-1 lists common malfunctions which may occur during operation or maintenance of Mod Lab A or its components.
The test/inspection and corrective actions are to be performed in the order listed.
This manual does not list all malfunctions or corrective actions that may occur. If a malfunction is not listed or is not
corrected by corrective actions, notify your supervisor.
3-2.
TROUBLESHOOTING.
Use the symptom index in Table 3-1 for quick access to the troubleshooting procedures in Table 3-2.
|
|
