TM 10-6640-238-13
2-48
NOTE
Perform the following steps when setting up Mod Lab A for initial use at a site. After
initial set up, perform only necessary steps to place Mod Lab in operation.
j.
Water System. Perform the following steps to place the water system in operation. (Refer to figure 2-9 for
location of control valves.)
(1) Fill Water Tank From Pressurized Source.
(a)
Open sink and water tank cam drains from under the trailer.
(b)
Unlatch and open Water Inlet access door.
(c)
Connect garden hose adapter (1, figure 2-16) to water system connector (2).
(d)
Attach 50-foot (15.25 m) garden hose to water inlet adapter (1).
(e)
Position WATER OUT/IN valve (3) to the IN position.
(f)
Secure opposite end of hose to pressurized water source.
1
3
2
MBPLA-2-17B
Figure 2-16. Water Inlet.
|
|
