Tweet |
Custom Search
|
|
|
||
TB 9-2330-381-14-1
2-3.
DUAL WINCH LOADING AND UNLOADING DISABLED PAYLOAD WITH MINE CLEARING BLADE
ATTACHED (CONT)
WARNING
Extreme caution must be used when removing winch cables from payload. Cable
may be under tension or be twisted. If winch cable has tension when removed,
slowly and carefully, using both hands, rotate cable to relieve tension. Do not
allow cable to twist or whip freely or serious injury to personnel may occur.
(79) Pull up on DRIVERS SIDE WINCH lever (34) to pay out driver's side winch cable (35) until winch cable
sags to ground and has enough slack to relieve tension in winch cable.
(80) Release DRIVERS SIDE WINCH lever (34).
(81) Check for twist in driver's side winch cable (35).
(82) Two persons remove cotter pin (25), shouldered pin (26), driver's side winch cable (35), payload tiedown
shackle (41), and towing shackle (48) from pintle (49).
(83) Remove linch pin (46) and keeper pin (47) and open snatch block (6).
(84) Remove driver's side winch cable (35), close snatch block (6), reinstall keeper pin (47), and secure with
linch pin (46).
(85) Place snatch block (6) in stowage position, install snatch block stow clamp (45), and secure by tightening
clamp handle (44).
WARNING
Extreme caution must be used when removing the winch cables from payload.
Cable may be under tension or be twisted. If the winch cable has tension when
removed, slowly and carefully, using both hands, rotate cable to relieve tension.
Do not allow cable to twist or whip freely or serious injury to personnel may occur.
(86) Pull up on PASSENGER SIDE WINCH lever (22) to pay out passenger side winch cable (23) until winch
cable sags to ground and has enough slack to relieve tension in winch cable.
(87) Release PASSENGER SIDE WINCH lever (22).
(88) Check for twist in passenger side winch cable (23).
(89) Two persons remove cotter pin (25), shouldered pin (26), and passenger side winch cable (23) from upper
left rear recovery eye (16) and lay winch cable (23) on platform.
2-88
|
||