| Tweet |
Custom Search
|
|
|
||
 TB 9-2330-381-14-1
2-3.
DUAL WINCH LOADING AND UNLOADING DISABLED PAYLOAD WITH MINE CLEARING BLADE
ATTACHED (CONT)
WARNING
Do not allow auxiliary winch cable to cross itself or knot up on winch or serious
injury to personnel may occur.
(23) With one person to operate winch controls and one person to ensure that winch cable devises do not hang
up on platform, push down on AUXILIARY WINCH lever (30) to pull drivers side winch cable (35) to snatch
block (6).
(24) If auxiliary winch cable (13) does not pull driver's side winch cable (35), push ENGINE SPEED CONTROL
switch (31) to HIGH ENGINE IDLE.
(25) Momentarily push ENGINE SPEED CONTROL switch (32) to lock engine speed at high idle (approximately
1500 rpm) and then release switch.
NOTE
To keep winch cable clevis from becoming stuck on platform, spotter should watch
clevis as it passes under payload.
(26) Release lever (30) when driver's side winch cable (35) reaches snatch block (6).
(27) Pull on driver's side winch cable (35) to get enough slack so cable can be passed through snatch block (6).
(28) Unfasten linch pin (46) from keeper pin (47), remove keeper pin (47) from snatch block (6), lift an d open
snatch block (6), and pass driver's side winch cable (35) through snatch block (6).
(29) Once driver's side winch cable (35) is past pulley on snatch block (6), close snatch block (6) and reinstall
keeper pin (47).
(30) Secure keeper pin (47) to snatch block (6) by installing linch pin (46).
(31) Push down and hold AUXILIARY WINCH lever (30) to pull driver's side winch cable (35) to front of platform.
(32) Release AUXILIARY WINCH lever (30) when driver's side winch cable (35) is approximately 12 inches (30
cm) past streetside front of platform.
WARNING
Prior to disconnecting any winch cables, be sure each cable is not twisted. A
twisted winch cable, when operated, can develop extreme tension, which may
cause serious injury to personnel when cable clevis is removed.
2-78
|
||
|
||
