| Tweet |
Custom Search
|
|
|
||
 TB 9-2330-336-14
VEHICLE PREPARATION (continued)
Roadside:
1.
Remove electrical conduit.
2.
Remove fire extinguisher and mount.
3.
Remove roadside clearance light and lead assembly.
FTSS SYSTEM PROCEDURE
The source and application of the FTSS System is proprietary. For vehicle preparation, applications, and
reapplication of the FTSS System, contact VSE Corporation, 2550 Huntington Avenue, Alexandria, VA 31902.
Or you may submit your request by phone (800) 455- 4873 or fax (703) 960-2688.
FOLLOW-ON TASK
The following is a list of components that are reinstalled after the FTSS coating has been applied, dried, and
inspected. For component installation instructions, spare, and mandatory replacement parts, refer to TM 9-2330-
356-14 and TM 9-2330- 356-24P (M969/M969A1) or TM 9-2330- 398-24 and TM 9-2330-398- 24P (M969A2).
Front Bulkhead:
1.
Install drain tubes (M969A1 only).
2.
Install electrical conduit.
3.
Install electrical access cover.
4.
Install right and left maker lights and lead assemblies.
5.
Install service air glad-hand cover.
6.
Install emergency air glad-hand cover.
Curbside:
1.
Install air cleaner.
2.
Install battery cover.
3.
Install front and rear reflectors.
4.
Install curbside clearance light and lead assembly.
Rear Bulkhead:
1.
Install ladder assembly.
2.
Install drain tubes (M969 only).
3.
Install spare tire and spare tire carrier.
4.
Install license plate and frame (as applicable).
5.
Install electrical conduit.
6.
Install triple warning lights and lead assembly.
7.
Install fire extinguisher and mounting bracket.
8.
Install gas can and mounting bracket.
9.
Install right composite light and lead assembly.
10.
Install left composite light and lead assembly.
11.
Install DOT placard (as applicable).
Roadside:
1.
Install electrical conduit.
2.
Install fire extinguisher and mount.
3.
Install roadside clearance light and lead assembly.
3-2
|
||
|
||
