in end of handcrank ratchet. Install x 6 binding-
head rivet through ratchet and handle. Peen end of
rivet over end of handle. Chack that handle rotates
arbor press, press pawl pin into pawl.
pin seats in hole provided in handcrank ratchet. In-
stall ratchet, gear end first, into handcrank ratchet.
It may be necessary to rotate the pawl pin slightly
to provide clearance for the ratchet. Install cover plate
cover plate by installing three x
Install pawl lever. Install 5/16-inch
ball and compression spring in handcrank ratchet and
crank in accordance with lubrication order (fig. 32).
f. Installation. Refer to paragraph 69b (2).
101. Stowage Box and Stowage Compartment
(1) R e m o v a l .
(a) Support the stowage box and remove nine cap screws,
lockwashers, plain washers, and hex nuts which se-
cure front edge of stowage box to side rail of body
(b) Remove six cap screws, lockwashers, plain washers,
and hex nuts which secure rear of stowage box to
right longitudinal beam of chassis frame.
Remove eight cap screws, lockwashers,
(2) D i s a s s e m b l y .
and hex nuts which secure each door to stowage box.
(3) C l e a n i n g .
Use steam and stiff brush to remove dirt.
vent to remove grease.
(4) I n s p e c t i o n a n d r e p a i r . Inspect stowage box and doors
for damage, bare metal, or damaged paint. Straighten
bends in metal and if cracked, repair. Refer to TM
9-2852 for welding theory and application. Scrape bare
spots or damaged paint to the metal and repaint. Door
locks are fitted and spot welded in door openings. Metal