Quantcast Slide Bolt Assemblies

Custom Search

TM 9-2330-380-14&P
4-69. Slide Bolt Assemblies
This task covers:
a. Removal
b. Inspection and repair
c. Installation
Initial Setup:
Tools/Test Equipment:
General mechanic's tool kit (item 01, Appendix B)
a. Removal
1. Remove screws (6) and washers (7) securing upper and lower
locking rods (8 & 9) to slide bolt assemblies (5). Remove
locking rods.
2. Remove four bolts (1), spacers (2), washers (3) and nuts (4)
securing each slide bolt assembly (5). Remove slide bolt
b. Inspection and repair
1. Inspect parts for cracks, bends, excessive wear and
deterioration. Replace defective parts.
2. Straighten locking rods to assure proper alignment in upper
and lower bolt slide fasteners.
3. Straighten bends or dents in slide bolt assembly covers that
may cause binding.
4. Check lock for ease of operation. Using grease fitting on handle lock assembly, lubricate in accordance
with Appendix I, Lubrication Instructions.
5. Clean and paint if necessary.
6. Replace defective parts.
c. Installation
1. Position slide bolt assembly (5). Secure with four bolts (1), spacers (2), washers (3) and nuts (4).
2. Position upper locking rod (8) on upper slide bolt assembly (5). Position lower locking rod (9) on lower
slide bolt assembly (5).
3. Secure locking rods to slide bolt assemblies with screws (6) and washers (7).
Follow-on maintenance: None


Privacy Statement - Copyright Information. - Contact Us

Integrated Publishing, Inc.