Custom Search
 
  
 


TM 9-2330-330-14&P
ENGINE TROUBLESHOOTING--Continued
0023 00
Table 1. Troubleshooting Procedures--Continued
TEST OR INSPECTION
CORRECTIVE ACTION
MALFUNCTION
4.
Check engine solenoid
1.
ENGINE STARTER WILL
If 2428 V dc are present at
start terminal for 2428 V
engine starter terminal, go to
NOT RUN--Continued
dc with engine start switch
step 5. If 2428 V dc are not
in START position.
present at terminal, repair wiring
between engine start switch and
solenoid (refer to WP 0065 00).
5.
Check solenoid to starter
If 2428 V dc are not present at
terminal for 2428 V dc.
solenoid to starter terminal,
replace starter (refer to WP 0119
00). If 2428 V dc are present at
solenoid to starter terminal,
replace engine starter. Verify
problem is solved.
2.
ENGINE TURNS OVER
1.
Check fuel lines for leaks
If fuel lines are leaking/damaged,
BUT FAILS TO START
or damage.
tighten all connections and
repair/replace any damaged fuel
lines (refer to WP 0109 00).
Verify problem is solved. If fuel
lines are not leaking, go to
step 2. If fuel lines still leak, notify
Direct Support maintenance.
2.
Bleed fuel system.
If no fuel flows while fuel system
is being bled, replace fuel pump
(refer to WP 0107 00). Verify
problem is solved. If fuel flows,
go to step 3.
3.
Check for dirty fuel.
If fuel is dirty, drain and remove
fuel tank (refer to WP 0108 00)
and fuel lines and replace and
refill tank with clean fuel.
Replace fuel filter (refer to WP
0109 00). Verify problem is
solved and go to step 5. If fuel
was okay, go to step 4.



 


Privacy Statement - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business