| Tweet |
Custom Search
|
|
|
||
 TM 9-2330-329-14&P
ENGINE FAN BELT REPLACEMENT--Continued
0104 00
2.
Remove three nuts (4) and lockwashers (5) from outer pulley half (6). Discard lockwashers.
3.
Remover outer pulley half (6) and fan belt (7). Discard fan belt.
INSTALLATION
1.
Install new belt (7), outer pulley half (6), three new lockwashers (5), and nuts (4).
2.
Alternately tighten nuts (4) on outer pulley half (6), while slowly rotating crank shaft pulley bolt (8).
NOTE
After tightening belt per step 2, belt deflection
should be 3/16 (4.8 mm) to 1/4 in. (6.4 mm). If
deflection exceeds 1/4 in. (6.4 mm), remove outer
pulley half and one shim. Repeat steps 1 and 2
until proper deflection is achieved.
When installing grille, note that the two short
screws fit in the two lower holes in grille.
0104 00-2
|
||
|
||
