Install Sump Pump. See Figure 5-8.
Position sump pump (1) in drain tank (8).
Install switch (22) to retaining bracket (14) and secure with two screws (20) and washers (21).
Position retaining bracket (14) on drain tank stand (19) and secure with eight screws (15), washers (16),
lockwashers (17) and nuts (18).
Install sump pump (1) on retaining bracket (14) and secure with two u-bolts (13), spacers (12), four washers (11)
and nuts (10).
Position cover (7) over drain tank (8) and connect discharge hose (9) to top of sump pump (1).
Connect two electrical leads at wire splices (5) and install heat shrink tubing.
Tighten two strain reliefs (6) to top of cover (7).
Install drain trap (3) on sink drain (4) and tighten two unions (2).
Plug sump pump connectors into receptacle located in cabinet W2.
Prepare and operate water system using internal water tank as source in accordance with procedures listed in
Inspect for leaks and check for proper operation.
Install water level regulator (Paragraph 4-54).