Install Water Tank. See Figure 5-2.
Apply teflon tape to male fittings. Be sure to wrap tape in same direction as pipe thread.
Install drain valve (1) and tee (22) on water tank (2). Close drain valve.
Install pipe fittings on water tank (2).
Position water tank (2) on tank support legs (21) and secure with two screws (17), nuts (18), lockwashers (19), and
washers (20) in each tank support leg.
Install tee flange (16) and gasket (15) to tank drain line and secure with six screws (11), nuts (12), lockwashers (13),
and washers (14).
Connect drain line union (10).
Connect union (9) on suction line from water pump.
Connect two unions (8) at water return lines.
Connect union (7) at overflow drain line.
Connect two unions (5) and switch (6) at top of water tank (2).
Connect three unions (3) and water flow direction valve (4) at top of water tank (2).
Connect unions and any obstructing plumbing disconnected during removal.
m. Install water pump (Paragraph 5-5).
Prepare and operate water system using internal water tank as source in accordance with procedures listed in
Inspect for leaks and check for proper operation.