TM 10-6640-215-13 4-55. REMOVE/INSTALL ROADSIDE STOWAGE BOX - continued. 3. Remove of Stowage Box Hinges, Hasps, Strikers and Door Panels.  See figure 4-55. a. Drill out eighteen rivets attaching latches and strikers to stowage box door panels and box base. b. Remove defective latches and strikers. c. Drill out sixteen rivets attaching hasps and strikers to stowage box door panels and box base. d. Remove defective hasps and strikers. e. Drill out thirty-six rivets attaching hinges to the stowage box and door panels. f. Remove defective hinges from the stowage box and door panels. INSTALLATION 1. Install Stowage Box Hinges, Hasps, Strikers, and Door Panels.  See figure 4-55. a. Place new hinges on the door panels and align the holes.  If new panels are being used, place the hinges into position and mark hole locations then drill out the holes. b. Rivet  the  hinges  to  the  door  panels.    Place  door  panels  with  hinges  into  position  on  the  stowage  box  and attach with rivets. c. Position  new  latches  on  the  door  panels  and  align  holes.    If  new  door  panels  are  being  used,  place  the latches into position and mark hole locations then drill out the holes. d. Position latch strikers on the box base. e. Rivet the latch strikers to the box base. f. Position hasps on the door panels.  If new door panels are being used, place the hasps in position and mark hole locations then drill out the holes. g. Rivet the hasps to the door panels. h. Position the new hasp strikers on the box base. i. Rivet the hasp strikers to the box base. 2. Install Stowage Box Hanger Channels.  See figure 4-55. 4-147